03-24-2020 12:29 PM
Hi community,
I discovered starange behavior with AP305C and AP510C/AP650 as well. I have radio-profile for these AP families. Some devices are configured with my own radio profile and some not. All devices are in the same location, same network policy. I can see at the device level that AP should use my radio profile, but if I check radio profile config through CLI or Config Audit, I can see the default one.
Device level:
Device Template:
Reality from CLI:
adio profile radio_ng_11ax-5g
radio profile radio_ng_11ax-5g phymode 11ax-5g
radio profile radio_ng_11ax-5g acsp access channel-auto-select time-range 01:00 04:00 station 0
radio profile radio_ng_11ax-5g acsp max-tx-power 20
...
What I am doing wrong? Suggestions? I have another AP510/650, which is configured properly ...
Solved! Go to Solution.
03-25-2020 10:15 AM
It may be running device level config instead of template/policy config. You may be able to do the following: From the manage device tab > tick the AP > actions > reset device to template defaults
Push the config either through delta or a complete. Does the AP then have the correct RP?
03-26-2020 07:02 AM
Thanks Ashley, this solved my problem.
03-25-2020 10:15 AM
It may be running device level config instead of template/policy config. You may be able to do the following: From the manage device tab > tick the AP > actions > reset device to template defaults
Push the config either through delta or a complete. Does the AP then have the correct RP?
03-25-2020 09:38 AM
I'd reset one of these APs to factory defaults and deploy the config again.