Upload older HiveOS firmware to hivemanager classic online.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-19-2018 03:22 PM
Can it be done? I have some WAPs that are at 6.6, and want to go to 8.0 first before 8.2. but it is not in the list on the OS dropdown.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-19-2018 07:34 PM
Ok thanks. I have port 22 blocked outbound. I will see what I can do, now that I found the issue.
THANKS for your assistance!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-19-2018 07:22 PM
Unfortunately we don't have a list, it would have to be so large to accommodate some of our dynamic scopes that it would be virtually unusable. Generally we suggest allowing the following ports to pass outbound traffic: UDP 12222, TCP 22, HTTP 80, TCP 443.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-19-2018 07:11 PM
I found it was blocked on my firewall. I created and ACL to allow any inside to 34.225.92.51 and was able to upgrade. are there a list of aerhive IP ranges that I can put in an ACL to allow to?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-19-2018 07:06 PM
I tested on 8 WAPs. 4 successfully updated. 3 stopped at 55% with no error, and one gave me this error
"An error occurred when executing the following CLI command: save image scp:/​/​******@34.225.92.51:/​HiveManager/​downloads/​home/​image/​AP230-8.0r1a.img.S 04:05:00 2018-06-28 no-prompt _password ******.
The Aerohive device was unable to upgrade image to flash memory because there is not enough memory in the device or there is error occued during the file transfer process."
