Hi, thanks for taking the time to look at this.
So I have a AP downstairs, AP230 wired into the network, and an AP upstairs, AP230 using the wireless backhaul to uplink a switch. The issue is, I can’t connect to any device on the wireless backhaul switch, when using the wireless network, but it works from the wired network connected to AP1
Note: I only have access to the CLI, I don’t have hivemanger.
Firmware: 10.0r8
Devices: AP230
Configurations:
AP1 - AP230 - Main AP - Ethernet Uplink
****************************************************************************
radio profile 2.4-Ghz
radio profile 2.4-Ghz phymode 11ng
radio profile 5.2-Ghz
radio profile 5.2-Ghz phymode 11ac
radio profile 5.2-Ghz channel-width 80
no radio profile 5.2-Ghz backhaul failover
security-object WiFi-S
security-object WiFi-S security protocol-suite wpa2-aes-psk ascii-key
ssid 2.4-Ghz
ssid 2.4-Ghz security-object WiFi-S
ssid 5.2-Ghz
ssid 5.2-Ghz security-object WiFi-S
hive Hive
hive Hive password
interface eth0 native-vlan 1
interface wifi0 radio profile 2.4-Ghz
interface wifi0 radio channel 11
interface wifi1 radio profile 5.2-Ghz
interface wifi1 radio channel 36
interface mgt0 hive Hive
interface wifi0 ssid 2.4-Ghz
interface wifi1 ssid 5.2-Ghz
interface mgt0 ip 192.168.0.1 255.255.255.0
no system web-server enable
no capwap client enable
****************************************************************************
AP2 - AP230 - Secondary AP - Wireless Backhaul Uplink
****************************************************************************
radio profile 5.2-Ghz
radio profile 5.2-Ghz phymode 11ac
radio profile 5.2-Ghz channel-width 80
no radio profile 5.2-Ghz backhaul failover
hive Hive
hive Hive password
interface eth0 mode bridge-802.1q
interface eth0 native-vlan 1
interface eth0 mac-learning enable
no interface eth0 inter-station-traffic
interface wifi1 radio profile 5.2-Ghz
interface wifi1 mode backhaul
interface wifi1 radio channel 36
interface mgt0 hive Hive
interface mgt0 ip 192.168.0.2 255.255.255.0
no system web-server enable
no capwap client enable
****************************************************************************
Results, the AP's are both talking via the backhaul network and I can access the clients bridged from AP2 using the wired network connected to AP1.
The issue is when I try to use the Wireless network broadcast from AP1 I can access anything on the bridged network via AP2
Any help would be appriciated.
