Data Center (MLX & CER/CES) - Page 3 - Extreme Networks

Data Center (MLX & CER/CES)

Questions and discussions about MLX/CER/CES

Forum Posts

Sorted by:

Start a conversation

I am not able to access Brocade MLXe8 switch through console

Hi,I am not able to access Brocade MLXe8 switch through console although I am using the native console cable with the converter and valid session parameters.it shows connected but no data on screen please advice

Resolved! DSCP rewritten on VLL

I’ve got two VLL’s for a customer that are configured identically. The A end of both tunnels are on the same CER and the Z end goes to two different MLX units. One of the VLL’s has no problem, but the other one does. I have narrowed the problem do...

Resolved! Enabling Advance routing on NI-CER series

Good day -We have a NI-CER-2048CX-RT-AC with IP_ROUTE_SCALE and NI-CER-2048-ADV licenses on it. We are trying to enable the ADV license so we can increase the max IP-Routes. Any commands that need to be run specifically? Thanks --

OSPF over GRE with MTU set to Jumbo

I have multiple links between the MLX routers connecting to other vendor devices (Ruckus ICX7750 and Cisco Catalyst 9500) via GRE which randomly get stuck in OSPF Exchange start. While the MTU at each end matches, I am able to restore the service by...

Ironware secondary image was not upgraded on the Line cards on MLX-4

Hello, I was able to successfully upgrade an MLX-4 to version 6.2.00d.Yet , when i issue the show flash command , the S1 through S4 show that the primary Ironware was upgraded to 6.2.00d , however the secondary image did not get upgraded to 6.2.00d o...

Top Kudoed Authors

User

Count

2

1

1

1

GTM-P2G8KFN