Enabling Advance routing on NI-CER series

[snoop42]

Good day -

We have a NI-CER-2048CX-RT-AC with IP_ROUTE_SCALE and NI-CER-2048-ADV licenses on it.  We are trying to enable the ADV license so we can increase the max IP-Routes.   Any commands that need to be run specifically?   Thanks --

[snoop42]

Hoping the techs are missing something as they just sent this:

system-max ip-cache 1200000
Error - Parameter ip-cache should be between 4096 and 524288

system-max ip-route 1200000
Error - Parameter ip-route should be between 4096 and 524288

[joergkost]

enable
conf t
system-max ip-cache 1200000
system-max ip-route 1200000
system-max ipv6-cache 120000
system-max ipv6-route 120000
wr mem

and then if you are ready, reload the router with reload

[snoop42]

Thanks a lot Joerg.   The guy who used to handle our Brocade configs is no longer here - is there a command/prompt needed to raise the system max?   Appreciate the help!

[joergkost · Accepted solution]

The NI-CER-2048CX-RT-AC  comes factory installed with the IP_ROUTE_SCALE, so it looks fine. From my point of view, you only need to raise the system-max(es) and should be good. 

[snoop42]

Thanks for the quick reply -

here is how it shows up:

NetIron CER 2048CX#show license
Index   Package Name              Lid          Slot    License Type    Status     License Period
1       NI-CER-2048-ADV            ###   M       normal          active     unlimited
2       IP_ROUTE_SCALE           ###   M       normal          active     unlimited

Does that help?