Enabling Advance routing on NI-CER series

[snoop42]

Good day -

We have a NI-CER-2048CX-RT-AC with IP_ROUTE_SCALE and NI-CER-2048-ADV licenses on it.  We are trying to enable the ADV license so we can increase the max IP-Routes.   Any commands that need to be run specifically?   Thanks --

[snoop42]

Unfortunately there is no support on the unit..  Sounds like we may be out of luck on this?     Thanks for all of your help Joerg - it is greatly appreciated...

[joergkost]

Do you have support on that box? Because it seems you need to change the chassis type, that is stored inside the EEPROM to solve this issue and make the license being fully accepted.  

[snoop42]

Here is what is showing up - hope this helps?  

Result:
hw pid show

=== Manufacturing Information ====
Board Class : 0x25 (Metro 1Gx48 Copper + 2X10G)
Factory Assembly Part Number : 40-1000369-01
Chassis Type: METRO-HEAVY (0x40) [FF]
Factory Serial Number : J7SA40E00B
Chassis Serial Number : K3SA40E00B
Power Type: Unknown (ff)
Date of Manufacture : 10-22-2009
Bench Test Status : PASSED
Burn-in Test Status : PASSED
Manufacturing Deviation : ������
RMA Number : ����������
OEM Vendor: None
OEM Vendor Serial Number: ��������������������
OEM Vendor Part Number: ��������������������
PCB Revision : ����
MFG Test : 042620
SW License Id: mIucJFgFFd

[joergkost]

Can you check the commands from this article?

https://extremeportal.force.com/ExtrArticleDetail?an=000077295&q=CER-2048CX-RT-AC