cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 

Brocade VDX firmware download from Switch to PC - 7.4.1c

Brocade VDX firmware download from Switch to PC - 7.4.1c

Svalbard_GM
New Contributor II

Hello,

I currently have a setup running on a Brocade VDX switch with firmware version 7.4.1c, which has been End of Support (EOS) since 2018. I need to upgrade a recently received RMA switch to match this version.

Since the firmware is no longer available on the Extreme Networks Downloads Portal, I would like to know if it's possible to download the firmware directly from one of the existing switches in my setup and then use it to upgrade the RMA switch.

I have WinSCP available for file transfer. Could someone please guide me on:

  1. The directory path where the firmware image is stored on the switch.

  2. How to download the file to PC.

Thank you for the support.

Regards,

Akshay

Regards
GM
1 ACCEPTED SOLUTION

Michael_Morey
Extreme Employee

The only thing I have seen close to what you are proposing was possible on the old chassis (8770) switches with multiple Management Modules.  When you insert a secondary MM, the primary will "firmware level" the new MM.  Once that is done you can take the Secondary out and put it in a different switch.  On 1U units this is not possible, you have to upgrade using a downloaded image.

Michael Morey
Principal Technical Support Engineer
Extreme Networks

View solution in original post

1 REPLY 1

Michael_Morey
Extreme Employee

The only thing I have seen close to what you are proposing was possible on the old chassis (8770) switches with multiple Management Modules.  When you insert a secondary MM, the primary will "firmware level" the new MM.  Once that is done you can take the Secondary out and put it in a different switch.  On 1U units this is not possible, you have to upgrade using a downloaded image.

Michael Morey
Principal Technical Support Engineer
Extreme Networks
GTM-P2G8KFN