cancel
Showing results for 
Search instead for 
Did you mean: 

New Documentation Published June 11th-17th!

New Documentation Published June 11th-17th!

SamPirok
Community Manager Community Manager
Community Manager

Our support teams published 44 new articles last week! Check out the new titles below!


Campus Fabric Articles

Which VOSS software release has support for RADIUS VLAN Create VSA? 

VOSS (FE): Syslog doesn't use TCP despite it being configured 

What does the log entry "GlobalRouter OSPF INFO Entering Helper Mode for OSPFv2 neighbor x.x.x.x ...... 

"Error: Associate VLAN to SPBM instance before create the VLAN" when creating SPBM backbone VLAN's (... 

VOSS- Block a list of IPs from learning over ISIS coming from a neighbor switch. 

With boot flag "nni-mstp enabled", unable to add NNI port to C-VLAN 

L3VSN does not work on Fabric Engine 5520 

What is "Last Reset Type: Management Reset" on an ERS Platform"?

 

Data Center Articles

VE interface not reporting speed correctly after migrating vlan associated with ve from Po 20(30G) t... 

Inconsistency when deleting EPG, Error : Bgp Neighbors are associated to VRF(s): vrf_VPN1570_SELI 

Princple switch telnet issue 

SLX Traps not seen on XIQ-SE 

Upgrading to EFA v3.1.2 fails due to mariadb client installation 

Major instabilities of SLX9850 PEs after XC swaps. OSPF neighbor changes. LACP state changes. CRC er... 

Missing LC on 9920 shows ports as down instead of LC being absent

 

EXOS Articles

Can you monitor the MACsec status using SNMP 

VRRPv3 IPv4 stays active/active with "Packet Verification failed" and "checksum incorrect" logs 

REST API query timeouts when LLDP neighbour information contains non-ASCII characters 

HAL Process crash in EXOS 30.7 

High "HAL" process utilization caused reboot 

Unable to run diagnostic extended on x435 switch on EXOS 32.3 and higher 

On EXOS/Switch Engine, is TCP Maximum Segment Size (TCP MSS) adjustment supported on VLAN interfaces...


Legacy Articles

XIQ-C - Monitor >Devices > Access point topology shows not secure 

Tunnelling of IPv6 on XIQ-C failing after Upgrade

 

SD-WAN Articles

How to allow my user to access ExtremeCloud SD-WAN? 

How to recognize SnapCall? 


Universal Articles

Is It Possible To Disable ICMP Timestamping In VOSS/VSP Switches 

How To Disable TCP Timestamping In VOSS/Fabric Engine 


WiNG Articles

AP310-I Adoption failed': Connection error 110 

WiNG APs sending authentication requests to old servers that have been removed from the controller c... 

WiNG | How to create OWE (Opportunistic Wireless Encryption) transition mode wlan 

AirDefense Enterprise remote LDAP user profile keeps changing 

Device in the Extreme Cloud IQ management has been unmanaged but cannot be deleted 

In AirDefense how to view the status of device discovery/import?  


XIQ Articles

All Access Points keep dropping CAPWAP connection and disconnecting from ExtremeCloud IQ 

Request of temporary license while replacing APs (XIQ) 

What is the difference Between "Name (SSID)" and "Broadcast Name"? 

ExtremeCloud IQ On Prem - AMD Host fails to boot properly. 

LLDP information do not display under XIQ for some AP 

How to Force Normal Power Mode when 'low power mode' is detected. 

AP5010 not broadcasting SSID 

APs installed at new location are getting connected to XIQ, but getting Configuration Update Failed ... 

What does Data rate HE-HE11 mean 


XMC Articles

LDAP connection fails from NAC with Connection *not* allowed via LDAP Config: is still in the quiet ...

 

If you have any requests for new articles, please let us know! You can either comment on this post, or email me directly at community@extremenetworks.com.

0 REPLIES 0
GTM-P2G8KFN