cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 

EWC sends data to Purview. Wan router also see the data

EWC sends data to Purview. Wan router also see the data

JohanHendrikx
Contributor II
After configuring EWC to send data to PurView Analiticys an strange problem happend.

The data that the AP send to Purview was detected by our wan router and send the to opur intenal firewall.

For the firewall thsi is spoofing because the networks are on the internal side.

I made a trace on oure firewall and the data was on the WAN interface

How can this be resolved ?

Johan Hendrik System Architect Audax
8 REPLIES 8

That article reflects method #1, Method #2 is configured directly via the XMC platform itself under configuration and then add it. See below.

5b71ccb901d9452295abbc2e00bbccef_RackMultipart20180709-57322-3kjj0e-addswitchPurview_inline.png

is this the document you refers to: https://gtacknowledge.extremenetworks.com/articles/How_To/Configuring-a-Identifi-Wireless-Controller...

When I check the wlan I see that netflow is enable. that's oke ?

Johan Hendrik System Architect Audax

JohanHendrikx
Contributor II
Yes the Purview/Analytics applicance and the EWC are across the WAN, The firewall is on the same location as the AP's
Johan Hendrik System Architect Audax

Mike_Thomas
Extreme Employee
Johan, is the Purview/Analytics appliance or the EWC across the WAN/FW from the other?
GTM-P2G8KFN