I have a cluster vx9000 and will adopt a AP310 remotely (L3)After adjusting the settings ip-mac conflict" and "ip-mac routing conflict, I can connect to the AP.The autoprovision rule is configured. however the AP connect to th RF-default instead con...
I've enabled 'collect port statistics' on ports of my switch.When I select interface history I can only see port Utilization, availability and bandwitchI want also see af graph of errors (rx, collinsions ect).Is this possible?
Firmware AP and controller are the same. Found the issue. There was a config mismatch in the profile ( ethernet ports vs Virtual interfaces).Thanks for your support.
Hello @Christoph_S I don't have to change manually the rf-domain and profile. Those are correct.When I login at the AP and look at the adoption status, the result is that the ap is adopted by the controller. However is the config of the AP there is...