cancel
Showing results for 
Search instead for 
Did you mean: 

ExtremeConnect - How to enable modules

ExtremeConnect - How to enable modules

StephanH
Valued Contributor III

Hello, 

beginning with version 8.5 some ExtremeConnect modules in XMC are hidden.

From Release Notes:

“Beginning with Extreme Management Center version 8.5, the following ExtremeConnect modules are hidden by default: 

  • FiberlinkMaaS360
  • FntCommand

If you have enabled one or more of these modules, it should not be hidden in your network; however, ExtremeConnect may hide the module if it is disabled at any time. Hidden modules are still fully functional, but cannot be configured automatically by ExtremeConnect. To enable a hidden module, modify the configuration file manually.”

So far so good.

But my question is how can I enable the hidden modules?

 

 

Regards Stephan
1 ACCEPTED SOLUTION

StephanH
Valued Contributor III

Hello,

I received the answer form GTAC:

https://extremeportal.force.com/ExtrArticleDetail?an=000059051

Thank’s to Bob.

 

Regards Stephan

View solution in original post

3 REPLIES 3

StephanH
Valued Contributor III

Hi Chad,

I asked the GTAC what is the understanding for  deprecated.
The answer was: These modules are no longer tested and developed, but still supported. There are no plans to remove the modules.

Regarding the function you can find hints here in the ExtemeConnect manual:
https://www.extremenetworks.com/support/documentation/extreme-management-center-8-5-0/

Regards Stephan

Chad5
New Contributor III

Hi,

I am looking into using extreme connect for VMWare, or Intune… but I am not sure what benefits can you get from that?

 

Say VMWare, which I believe is still supported and not deprecated. Anyone using that?

 

Thanks, 

StephanH
Valued Contributor III

Hello,

I received the answer form GTAC:

https://extremeportal.force.com/ExtrArticleDetail?an=000059051

Thank’s to Bob.

 

Regards Stephan
GTM-P2G8KFN