cancel
Showing results for 
Search instead for 
Did you mean: 

How to use the Netsight to sending alarm when port without inline-power supply?

How to use the Netsight to sending alarm when port without inline-power supply?

Chan_Ching-hsia
New Contributor
The Extreme switch X440 PoE fail always without error log.
When the PoE fail, CLI "show inline-power info" will return timeout.
Can I using the Netsight to notice me that the inline-power is fail?
And how to create the alarm when the port without inline-power supply?
10 REPLIES 10

Chan_Ching-hsia
New Contributor
I have found that the error message "Erro:HAL.Card.Error".
And how to use the syslog to trigger netsight sending the email?

Dorian_Perry
Extreme Employee
The PoE failures (Hardware and EXOS version) are similar to article:
Switch loses Power Over Ethernet until next rebooted

The recommendation is to contact GTAC for further investigation.

Prashanth_KG
Extreme Employee
Hi Chan,

Could you please check if you see any messages in the log like below:

06/26/2014 20:41:01.16 Slot-1: poePlusInit: Initialization failed Slot-1 DESWMUELEO13-OG4.2 # show inline-p sl 1 Timeout occured while retrieving information from hardware.Usually, we will have the poe plus init failure in the logs. May be this could be sent to the syslog server.

Chan_Ching-hsia
New Contributor
The X440 version is 16.1.2.14.
There is no PoE error log. So Netsight can't receive the error.

Dorian_Perry
Extreme Employee
Which EXOS version is running on the switch?
GTM-P2G8KFN