How to use the Netsight to sending alarm when port without inline-power supply?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎01-18-2016 06:18 AM
The Extreme switch X440 PoE fail always without error log.
When the PoE fail, CLI "show inline-power info" will return timeout.
Can I using the Netsight to notice me that the inline-power is fail?
And how to create the alarm when the port without inline-power supply?
When the PoE fail, CLI "show inline-power info" will return timeout.
Can I using the Netsight to notice me that the inline-power is fail?
And how to create the alarm when the port without inline-power supply?
10 REPLIES 10
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎01-20-2016 04:49 AM
I have found that the error message "Erro:HAL.Card.Error".
And how to use the syslog to trigger netsight sending the email?
And how to use the syslog to trigger netsight sending the email?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎01-19-2016 02:48 PM
The PoE failures (Hardware and EXOS version) are similar to article:
Switch loses Power Over Ethernet until next rebooted
The recommendation is to contact GTAC for further investigation.
Switch loses Power Over Ethernet until next rebooted
The recommendation is to contact GTAC for further investigation.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎01-19-2016 03:49 AM
Hi Chan,
Could you please check if you see any messages in the log like below:
06/26/2014 20:41:01.16 Slot-1: poePlusInit: Initialization failed Slot-1 DESWMUELEO13-OG4.2 # show inline-p sl 1 Timeout occured while retrieving information from hardware.Usually, we will have the poe plus init failure in the logs. May be this could be sent to the syslog server.
Could you please check if you see any messages in the log like below:
06/26/2014 20:41:01.16
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎01-19-2016 12:14 AM
The X440 version is 16.1.2.14.
There is no PoE error log. So Netsight can't receive the error.
There is no PoE error log. So Netsight can't receive the error.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎01-18-2016 02:59 PM
Which EXOS version is running on the switch?
