cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 

NetSight: AP 3630 , not completely discovered

NetSight: AP 3630 , not completely discovered

SC-Lantech
New Contributor
Hello, we have some AP 3630 and their status on NetSight Console is "Contact Established" but NetSight can't show the other information about version, s/n , mac-address and on Topology Map the APs appears with a "question mark" icon and without any connection to the switches.

For us is very important know the information of AP and where the AP are connected: why we can't obtain these details from NetSight Console and Topology Map?
Thanks a lot. Best Regards
1 REPLY 1

Paul_Poyant
New Contributor III
Though a "thick mode" AP3630 (by design, not under a wireless controller) does support SNMPv3, its effectiveness is somewhat constrained by the minimal number of supported MIBs. This is what we received from a full MIB walk of a lab AP3630:
    One of each: sysDescr, sysObjectID, sysUpTime, sysContact, sysName, sysLocation, sysServices One for each of three ports: ifIndex, ifDescr, ifAdminStatus, ifOperStatus One of each: etsysPolicyProfileMaxEntries, etsysPolicyProfileNumEntries, etsysPolicyProfileLastChange, etsysPolicyProfileTableNextAvailableIndex, etsysPolicyProfileName, etsysPolicyProfileRowStatus, etsysPolicyProfilePortVidStatus, etsysPolicyProfilePortVid, etsysPolicyProfileRulePrecedence
The values that you are seeking are not apparently available to SNMP.
GTM-P2G8KFN