SNMP Contact Lost: No SNMP reply from device caused by SNMP Error: General Error[5]
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-15-2016 01:33 PM
New switch. SNMP settings match other working devices EXACTLY, yet I'm getting this general error in the console alarms in netsight and I can't seem to find much documentation on it. Any experience with this?
5 REPLIES 5
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-15-2016 01:55 PM
read All write All notify All
instead of read all write all notify all....
I had no clue that was case sensitive. My life up to this point has been a lie....
Thank you.
instead of read all write all notify all....
I had no clue that was case sensitive. My life up to this point has been a lie....
Thank you.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-15-2016 01:55 PM
Funny! Thanks for joining the Hub Christopher. It's great to have you with us.
It takes a Community to run a modern network. Give a little and get a lot in return. That's what the Hub is all about. We all learn something every day!
It takes a Community to run a modern network. Give a little and get a lot in return. That's what the Hub is all about. We all learn something every day!
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-15-2016 01:44 PM
I suggest you use the command line on the device to verify the SNMP is setup exactly the same way. Look for a slight spelling or case issue.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-15-2016 01:41 PM
MIB tools returns no such device name. The interface summary flexview, likewise, returns nothing. The device is an SSA, I have the exact same profile assigned to many other SSA's with the same config working fine.
