SNMP contact lost to EXOS switch on fresh new EMC 8.04
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-09-2017 10:52 AM
I have a fresh new EMC 8.0.4.54 installation.
I have added new X460-G2 device using ZTP+ and everything was fine.
However, after 5-6 minutes I have an "Contact lost" alarm.
Device is fully IP-reachable: ping gives the response, "open device terminal" from EMC is working, I can also poll device with MIB Tools using default SNMPv3 creds.
Both SNMP processes have "ready" status on the switch.
EXOS is 22.3.1.4 patch1-4
When I rebooted the EMC, then I have "Contact established" back.
But after few minutes EMC lost the contact with the switch again.
Looks like it is EMC issue.
Any ideas ?
I have added new X460-G2 device using ZTP+ and everything was fine.
However, after 5-6 minutes I have an "Contact lost" alarm.
Device is fully IP-reachable: ping gives the response, "open device terminal" from EMC is working, I can also poll device with MIB Tools using default SNMPv3 creds.
Both SNMP processes have "ready" status on the switch.
EXOS is 22.3.1.4 patch1-4
When I rebooted the EMC, then I have "Contact established" back.
But after few minutes EMC lost the contact with the switch again.
Looks like it is EMC issue.
Any ideas ?
2 REPLIES 2
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-09-2017 02:06 PM
I was only able to change the poll type AFTER ZTP+ stage, i.e when switch moved from "Discovered" to "Devices" tab. When editing device during ZTP+ pending edit stage, changing poll type made the "Save" button changed to "Enforce Preview", which made me confused (?).
Anyway, snmp polling seems to be stable now.
Thank you, Stephen!
Anyway, snmp polling seems to be stable now.
Thank you, Stephen!
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-09-2017 12:47 PM
Robert, when you staged the switch did you change the poll type from ZTP to snmp? I'm not sure of people that use pool type ZTP right now.
