This user does not have permissions for this command.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎12-16-2021 10:23 AM
X440 connected to XMC/NAC used to autheticate the user for management login.
IF I try to connect to the switch with ssh the prompt is this :
X440_UP > and for any command I do I receive this error:
"This user does not have permissions for this command."
The problem is the connection to radius ( XMC/NAC ) but I do not know where ( I only upgraded to the last release XMC and NAC )
Thanks
Giuseppe
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎12-17-2021 10:58 AM
you can execute this command:
tcpdump -ni eth0 port 1812 -w /tmp/mypcap.pcap
then you can download the pcap file.
other option is to use GUI of the NAC engine and start the packet capture there
---
regarding your screenshots:
- is your user part of the user group condition
- is your switch part of the location condition
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎12-17-2021 10:42 AM
Giuseppe
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎12-17-2021 09:07 AM
Can you share PCAP of the radius access accept?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎12-17-2021 08:42 AM
Giuseppe
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎12-17-2021 08:23 AM
The policy mapping looks ok.
what about the rest of the config? I shared NAC rules, NAC profile, Switch config
