This user does not have permissions for this command.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎12-16-2021 10:23 AM
Good Afternoon,
X440 connected to XMC/NAC used to autheticate the user for management login.
IF I try to connect to the switch with ssh the prompt is this :
X440_UP > and for any command I do I receive this error:
"This user does not have permissions for this command."
The problem is the connection to radius ( XMC/NAC ) but I do not know where ( I only upgraded to the last release XMC and NAC )
Thanks
Giuseppe
X440 connected to XMC/NAC used to autheticate the user for management login.
IF I try to connect to the switch with ssh the prompt is this :
X440_UP > and for any command I do I receive this error:
"This user does not have permissions for this command."
The problem is the connection to radius ( XMC/NAC ) but I do not know where ( I only upgraded to the last release XMC and NAC )
Thanks
Giuseppe
18 REPLIES 18
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎12-17-2021 08:10 AM
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎12-17-2021 07:48 AM
hi Giuseppe.
I can not read anything from your picture.
I can not read anything from your picture.
Regards
Zdeněk Pala
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎12-17-2021 06:28 AM
Thanks for your reply.
this is my configuration and it does not work 😞
Giuseppe
this is my configuration and it does not work 😞
Giuseppe
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎12-17-2021 03:03 AM
check what radius attributes are sent from NAC to EXOS. For Admin access the EXOS you should receive Service Type = 6

here is my NAC rule:

Administrator NAC Profile uses Enterprise User (Administrator) policy

Policy Mapping for Enterprise User (Administrator)

The switch:

Good luck
here is my NAC rule:
Administrator NAC Profile uses Enterprise User (Administrator) policy
Policy Mapping for Enterprise User (Administrator)
The switch:
Good luck
Regards
Zdeněk Pala
