XOS - NetSight Compass not showing IP Address (Version 6.2.0.199)
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-06-2015 10:39 AM
When performing a Compass search in NetSight 6.2.0.199 with Summit X460-G2 switches, only MAC Addresses are displayed. No IP Addresses are populated.
8 REPLIES 8
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-25-2017 10:22 AM
Hi, Did you enabled node-alias on the switch? It's not enabled by default, you have to do it. Anticipating the question around default settings in EXOS, I'd encourage you to try ztp+ when adding a new switch (requires 21.1 or later on the switch), and then with EMC 8.0 you have the possibility to automatically run a script when that switch is added to a Site. That script could be your own default settings definition.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-25-2017 07:20 AM
Hello,
i also have this "issue"
x440g2 - 22.2.1.5patch1-4
Netsight 8.0.2.42
cannot find ip adresses in compass search
i also have this "issue"
x440g2 - 22.2.1.5patch1-4
Netsight 8.0.2.42
cannot find ip adresses in compass search
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-03-2015 12:37 PM
Is there any update on this, this is rather annoying as it was very useful on enterasys switches.
It is very handy to trace what port a device is plugged in just by IP address.
Netsight: 6.2.0.221
Extreme: X460-G2-48p-GE4 running 16.1.1.4-patch1-1
It is very handy to trace what port a device is plugged in just by IP address.
Netsight: 6.2.0.221
Extreme: X460-G2-48p-GE4 running 16.1.1.4-patch1-1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-17-2015 11:25 AM
Anybody also experiencing this?
