Aerohive AP250 and VOIP Phone

[rkowals]

Can I attach an IP phone to ETH1 on an AP250 so I can connect to our phone system, so the AP will be acting as a bridge.

[rkowals · Accepted solution]

I changed the ETH1 Port type from Access to Trunk and change the native VLAN to the Phone VLAN.

[Ronald_Dvorak]

@rkowals just to make sure I unterstand in case I run into the same issue... the solution was to set the ETH1 port to access or did you need to change anyting else ?

Thx,

Ron

[rkowals]

I’ve got it working, thanks again Sam

[rkowals]

I checked my switch port that it the AP is connected to, it’s a Trunk Port, Native VLAN 1, allowed all.

I moved it to another port, with native vlan 1 and VLAN 2,3,4,9:  2 being the VOICE vlan.  just to see