cancel
Showing results for 
Search instead for 
Did you mean: 

Essential Guest Aerohive Splash

Essential Guest Aerohive Splash

nick-vd
New Contributor

Hi

We are trying to setup the guest essentials. When we enable it none of the custom splash pages get chosen but an Aerohive Networks one that is not in our templates.

We are using a AP410C with firmware version 10.7.3.0. When we press register on the Aerohive page we get wireless access but we don't see any values inside of the gues essentials page.

1 ACCEPTED SOLUTION

Christoph_S
Extreme Employee

Hello @nick-vd,

When you run the following CLI command: #show station

Where are they connecting to?

Run command #show run | inc ssid, do you see any other CWP SSID. 

If all is configured properly, I would recommend you reach out to GTAC and open a support case for proper troubleshooting. 

BR,

Christoph S.

View solution in original post

4 REPLIES 4

Christoph_S
Extreme Employee

Hello @nick-vd,

When you run the following CLI command: #show station

Where are they connecting to?

Run command #show run | inc ssid, do you see any other CWP SSID. 

If all is configured properly, I would recommend you reach out to GTAC and open a support case for proper troubleshooting. 

BR,

Christoph S.

thanks

 

I made a case since all was showing up correctly.

Christoph_S
Extreme Employee

Hello @nick-vd,

Please start here:

Please make sure that these settings are properly configured:

  1. That you have selected the correct option in the SSID: Christoph_S_0-1730465577530.png

     

  2. The Onboarding rule is mapped to the correct SSID and location
  3. You've created a custom Template and mapped it to the correct SSID and location
  4. These settings have been saved

BR

Christoph S.

Hi @Christoph_S 

 

Thnaks for answering my question.

 

I can confirm that all of the above is set correctly and are being saved.

GTM-P2G8KFN