new AP5010 and AP4020 - no adequate power

[marconet_22]

Hi

I install n°4 AP4020 and n°1 AP5010 with Extreme Switch model x440-48P.

Every AP(s) consume energy from 9,0 to 9,3 W, I forced power negotiation to work with 802.3at standard.

From dashboard: ML Insight/Nwtwork 360 Monitor/Devices

In Device Health, section Adequate Power, I receive the following info, I see randomly that some AP have insufficient power. 

Every Radio(s) (wifi 0, wifi 1 and wifi 2) are UP 

From logs of Access Point(s) I don't receive any issue

How can check it? 

Is this log an issue? (Adequate Power)

[Raul_Carbonari]

Hi,

A short time ago I opened a ticket because this "Adequate Power" message only appears in XIQ-Classic and not in XIQ-New, where it was apparently fixed. GTAC responded that there is no forecast for a fix in XIQ-Classic...

In the case of the 5010, there is the option to configure the "POE Profile Override," adjusting this may make the message disappear.

Regards, Raúl