new AP5010 and AP4020 - no adequate power

[marconet_22]

Hi

I install n°4 AP4020 and n°1 AP5010 with Extreme Switch model x440-48P.

Every AP(s) consume energy from 9,0 to 9,3 W, I forced power negotiation to work with 802.3at standard.

From dashboard: ML Insight/Nwtwork 360 Monitor/Devices

In Device Health, section Adequate Power, I receive the following info, I see randomly that some AP have insufficient power. 

Every Radio(s) (wifi 0, wifi 1 and wifi 2) are UP 

From logs of Access Point(s) I don't receive any issue

How can check it? 

Is this log an issue? (Adequate Power)

[marconet_22]

Hi

The option is this?

 What option can i select?

[Raul_Carbonari]

Hi,

I think the "Default" option corresponds to the second column in the table, "AT Profile," where the radios remain 4x4:4 but neither USB nor PSE works.

It would be good if the "Default" label were changed to "No USB, No PSE," it would be much clearer.

Raúl

[marconet_22]

I think so, don't it put legend on the side right with different parameters.

Crazy!!