XIQ - How can I enable wired 802.1x port authentication

[StephanH]

Hello,

how can I enable wired 802.1x authentication for an XIQ AP so that the AP authenticate on a switch port?

[StephanH]

Hello Christian,

good, then I'm not the only blind :-).
XCA can do that like Identifi. But in both cases you have to configure something to make the authentication start.

I assume that XIQ can do that too. The only question is where to set it.

[CWurm]

Hi Stephan,

I would like to know this as well. IdentiFi APs have been able to do this and could authenticate themselves on their wired port by 802.1X PEAP or EAP-TLS but I haven’t seen any possibility on XIQ APs to do the same…

Kind regards

Christian

[StephanH]

Hello Sam,

apparently I have not described this clearly. I want to know where I have to enable the authentication at the AP. Typically there is a place where I say use which data he takes and what method to use, for example, for PEAP (User and Password) or EAP-TLS (Certificate). Enable authentication on the switch is no problem.

[SamPirok]

In general you should be able to set that up in the switch template, but if you can let me know which switch model you are using I can be more specific?