Enterasys S-series >> "Access control for the authentication header protocol is not supported."
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-07-2017 08:25 AM
Hi,
we need to convert an access-list from a Cisco to the new server router Enterasys S-series.
On the cisco I had the line:
"permit ahp any any"
I see that Enterasys S-series doesn't recognize the name "ahp", but I can still enable protocolo numbers (51 for AH)
So I did:
"permit 51 any any"
but I get:
"Access control for the authentication header protocol is not supported."
How should I permit the AH Protocol to pass through the access-list?
Thanks
we need to convert an access-list from a Cisco to the new server router Enterasys S-series.
On the cisco I had the line:
"permit ahp any any"
I see that Enterasys S-series doesn't recognize the name "ahp", but I can still enable protocolo numbers (51 for AH)
So I did:
"permit 51 any any"
but I get:
"Access control for the authentication header protocol is not supported."
How should I permit the AH Protocol to pass through the access-list?
Thanks
2 REPLIES 2
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-10-2017 02:10 PM
😞
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-10-2017 02:10 PM
Looks like it isn't supported.