Is CLI cammand of 800 series for OSPF similar to CLI command of EXos ?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-11-2016 07:02 AM
Hi,
I want to know can i configure OSPF for Switch 800 series with the same CLI commands of EXOS?
I want to know can i configure OSPF for Switch 800 series with the same CLI commands of EXOS?
4 REPLIES 4
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-19-2016 07:14 PM
Also for most tasks web management is easier to use for configuration on the 800 series. The cli can be a bit obtuse.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-11-2016 11:26 AM
Hello,
Static routing only on the 800 Series.
The CLI structure and syntax are unique to the 800 Series - no relation to EOS or XOS.
Regards,
Mike
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-11-2016 08:41 AM
I don't think that the 800 supports OSPF - it's a cheap access switch.
The switch doesn't run XOS - so you can't use the same commands.
The switch doesn't run XOS - so you can't use the same commands.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-11-2016 08:41 AM
I think it supports OSPF, but i didn't found the Commands to implement 😞