cancel
Showing results for 
Search instead for 
Did you mean: 

load mib to A2H124

load mib to A2H124

Nikos_Tsachalis
New Contributor
Hi community,

we have a switch A2H124-48P which is not sending snmp traps when a cable is unplugged. I used snmpwalk and found that the O.I.D. .1.3.6.1.6.3.1.1.5.3 is not responding (IF-MIB). This OID is responsible for sending the trap. I have seen in documents that the IF-MIB is supported by A2 series switch but in our case, it is missing. Is there a way to load it on the switch? Is it a matter of firmware?(current version Rev 02.01.10.0001)
3 REPLIES 3

Ricardo_Barroso
New Contributor
Gentlemen, what are the MIBs that I need to monitor the status of the stack?

Senhores, quais são as mibs que eu preciso para monitorar o status do empilhamento do A2H124
?

Nikos_Tsachalis
New Contributor
You are right , I shouldn't expect this oid to respond since it is a trap.

JAMES_WIEDEL
New Contributor II
Nikos,
The OID you sent is for the trap itself and you can not poll it.
Do you get *any* traps from the switch? If not, you need to check your SNMP configurations.
In particular

show snmp notify
show snmp targetaddr
show snmp targetparams

which control the traps.
I am assuming SNMP in general works.

You could try loading "new" code into the switch. I was looking at an A2 with version
03.03.02.0002 which you should be able to download from the Extreme support site.
It will be hiding in the Legacy gear section.
James

GTM-P2G8KFN