I have a switch with the following config:
#spantree
set spantree mstcfgid cfgname 'SP4' rev 1
set spantree msti sid 2 create
set spantree msti sid 3 create
set spantree msti sid 4 create
set spantree msti sid 5 create
set spantree mstmap 9 sid 5
set spantree mstmap 10 sid 5
set spantree mstmap 17 sid 5
set spantree mstmap 18 sid 5
set spantree mstmap 38 sid 5
set spantree mstmap 43 sid 5
set spantree priority 8192 0
set spantree priority 8192 2
set spantree priority 8192 3
set spantree priority 8192 4
set spantree priority 8192 5
set host vlan 9
So with this config, this switch should be in SID 5. yet when I run show spantree stats i get:
Spanning tree status - enabled
Spanning tree instance - 0
Designated Root MacAddr - 3C:A8:2A:29:29:00
Designated Root Port - ge.1.23
Designated Root Priority - 0
Designated Root Cost - 20000
Root Max Age - 20
Root Hello Time - 2
Root Forward Delay - 15
Bridge ID MAC Address - 00:1F:45:91:FC:10
Bridge ID Priority - 8192
Bridge Max Age - 20
Bridge Hello Time - 2
Bridge Forward Delay - 15
Topology Change Count - 1634
Time Since Top Change - 0 days 0:01:58
Max Hops - 20
SID Port State Role Cost Priority
--- ---------- ---------------- ----------- -------- --------
0 ge.1.23 Forwarding Root 20000 128
0 ge.1.24 Forwarding Designated 20000 128
Why is this switch in SID 0????
