11-11-2021 03:15 PM
11-12-2021 08:29 AM
11-12-2021 10:27 AM
Additionally,
I'd check 'show port <#> configuration no-refresh' to make sure the port is configured for 10G. If it's not, you can use the following command to change the speed/negotiation on that port:
configure port <#> auto [on | off] speed <MBPS> duplex full
Also, 'show port <#> transceiver info detail' will show you if incoming light is being detected.
11-11-2021 04:45 PM