Add vlan to existing switch and ospf routing

[Sidney_Yoder]

Not able to ping new vlan default gateway

Name VID Protocol Addr Flags Proto Ports Virtual Active router /Total

---------------------------------------------------------------------------------------

corp_CTAP_agents 3710 10.131.82.1 /24 -f----------------------- ANY 0 /1 VR-Default

CTAP-Agent 500 192.168.112.1 /24 -f----------------------- ANY 80/132 VR-Default

Default 1 --------------------------------------------- ANY 0 /0 VR-Default

EVN 501 10.20.50.1 /24 -f----------------------- ANY 1 /3 VR-Default

IPC 502 172.16.50.1 /24 -f----------------------- ANY 1 /4 VR-Default

IVN 503 192.168.50.1 /24 -f----------------------- ANY 1 /7 VR-Default

Mgmt 4095 --------------------------------------------- ANY 0 /1 VR-Mgmt

XO_VPLS_MESH 1000 10.128.254.4 /24 -f-------o--------------- ANY 1 /1 VR-Default



VLAN Interface with name corp_CTAP_agents created by user

Admin State: Enabled Tagging: 802.1Q Tag 3710

Description: None

Virtual router: VR-Default

IPv4 Forwarding: Enabled

Primary IP : 10.131.82.1/24

IPv6 Forwarding: Disabled

IPv6: None

STPD: None

Protocol: Match all unfiltered protocols

Loopback: Disabled

NetLogin: Disabled

QosProfile: None configured

Egress Rate Limit Designated Port: None configured

Flood Rate Limit QosProfile: None configured

Ports: 1. (Number of active ports=0)

Untag: 3:44

[Bill_Stritzinge]

Sidney,

Not sure I have everything correct, but if you created the vlan corp_CTAP and need to ping the default route on the OSPF interface XO_VPLS_MESH, if you are using full dynamic routing you need to have OSPF enabled on the corp_CTAP vlan.. Can you show me the output of "show iproute" and give me a little more background on what it routing where?

Bill