Auto on/off at X670

[Irwanto_Widians]

Hi Everyone , I have some question regarding auto on /off at extreme x670,

1. I want to auto on speed 100 duplex full, but there are errors like this
Error: Speed specified is not supported on port 6.
and then i checked the type in this port is BaseT

SW-02-L1-01.1 .2 # sh ports 6 information detail
Port: 6(port_test):
Virtual-router: VR-Default
Type: BASET (Industrial Temperature)
Random Early drop: Unsupported
Admin state: Enabled with 10G full-duplex
Link State: Ready
Link Ups: 0 Last: --
Link Downs: 0 Last: --

VLAN cfg:
Name: Vlan_test, Internal Tag = 10, MAC-limit = No-limit, Virtual router: VR-Default
STP cfg:

Protocol:
Name: Vlan_test Protocol: ANY Match all protocols.
Trunking: Load sharing is not enabled.

EDP: Enabled

2. current configuration in port 2 is auto on, and I want to change to auto off but could not and there is an error
SW-02-L1-01.2 # configure ports 2 auto off speed 1000 duplex full
Error: Auto negotiation off is not supported on port 2 at 1G speed.

If someone can help It would be greatly appreciated.

Regards

[Irwanto_Widians]

Thanks for replay Ronald,
1. I still do not understand, I have a case that the device connected to the port 6 can only run at 100 Mbps, so what should I do? at this time link still ready
2. by default auto negotiation on the x670 is on or off?

[Ronald_Dvorak]

1) auto on, speed 100, duplex full - if auto negotation is set to enabled why would you set speed/duplex.
But here a post about the fibre port regarding auto neg...
https://community.extremenetworks.com/extreme/topics/negotiation_1000_10000_with_x670_and_sfp

2) auto must be on for a 1G port
https://community.extremenetworks.com/extreme/topics/set_speed_and_duplex_command