Can not see/apply the created policy

[Vasiliy_N]

Hi all.

For some reason i cannot see or apply the created policy on interface.

I can see the policy using the 'ls' command, but if i try to use 'show policy' I do not see this policy in the list of available policies. 'check policy' for this file ends successfully.
If i try to apply the policy on an interface i get:
Error: ACL policy not found
Configuration failed on backup MM, command execution aborted!

Platform is BD-X8, 15.7.2.9 version.

Thank you in advance.

[Vasiliy_N]

Also when I try to save the policy after editing, the message appears:

Synchronizing to backup MSM ...

This message can hang indefinitely, but if I check the status in another ssh session with a 'show switch' command i'll see that backup MM is synchronized:

MM-B
------------------------
BACKUP (In Sync)

[Vasiliy_N]

Hello Brad.
Thank you for you reply.

I am trying to apply policy with 'configure access-list ports 2:13 ingress' and i don't use the .pol extension.

What i get is:
Error: ACL policy not found
Configuration failed on backup MM, command execution aborted!

[BradP]

Hi Vasiliy N,
"show policy" is for applied policy. Don't forget when applying a policy, the extension isn't needed.
Brad