create a 801.1q trunk on the fiber to connect the two switches
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-20-2014 04:12 PM
Hi Folks,
I'm trying to setup a vlan between a pair of summit 200/48's. So far I've got the vlan configured on both ends, I've configured the ports on both ends, and I'm stuck on creating a 801.1q trunk.
Can anyone point me in the right direction?
I'm trying to setup a vlan between a pair of summit 200/48's. So far I've got the vlan configured on both ends, I've configured the ports on both ends, and I'm stuck on creating a 801.1q trunk.
Can anyone point me in the right direction?
5 REPLIES 5
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-20-2014 08:27 PM
well I just confirmed with my provided that from the jack on the modem to the phone it is converted to analog so I don't think this is going to work.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-20-2014 05:07 PM
I'm not getting a dial tone through it... do I have to set static IP's on the ports on each end? such as 10.0.0.2 and 10.0.0.3 respectively?
I don't think it's VOIP... I think it's an analog line brought in from our cable provider... if that matters.
I don't think it's VOIP... I think it's an analog line brought in from our cable provider... if that matters.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-20-2014 04:57 PM
Hey Tourless it doesn't matter for VOIP so it looks great are there any other questions? P
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-20-2014 04:51 PM
Hi Paul, and thanks for the reply. I previously created the vlan and added a port as follows...
create vlan 3
config 3 tag 3
config 3 add port 12 tagged
config 3 ipaddress 10.0.0.1/24
I did the same on both switches.
Not sure if it matters but I probably mention this is for voice traffic... I'm trying to dedicate one port on each switch for a direct dial phone line that is being used as a fax.
create vlan 3
config 3 tag 3
config 3 add port 12 tagged
config 3 ipaddress 10.0.0.1/24
I did the same on both switches.
Not sure if it matters but I probably mention this is for voice traffic... I'm trying to dedicate one port on each switch for a direct dial phone line that is being used as a fax.
