Hi Folks,
I'm trying to setup a vlan between a pair of summit 200/48's. So far I've got the vlan configured on both ends, I've configured the ports on both ends, and I'm stuck on creating a 801.1q trunk.
Can anyone point me in the right direction?
I'm not getting a dial tone through it... do I have to set static IP's on the ports on each end? such as 10.0.0.2 and 10.0.0.3 respectively?
I don't think it's VOIP... I think it's an analog line brought in from our cable provider... if that matters...
Hi Paul, and thanks for the reply. I previously created the vlan and added a port as follows...
create vlan 3
config 3 tag 3
config 3 add port 12 tagged
config 3 ipaddress 10.0.0.1/24
I did the same on both switches.
Not sure if it matters but I p...
