edge port using safeguard

[shakil_khan]

on my XOS switch i want to make ports 1 & 3 as edge ports would the below command syntax do the trick?

create stpd s0 configure stpd s0 mode dot1w

configure stpd s0 default-encapsulation dot1d

configure stpd s0 add vlan Data ports 1,3

configure stpd s0 ports link-type edge 1,3 edge-safeguard enable

enable stpd s0

[PARTHIBAN_CHINN]

it should disable the port and enable it again after 5 minutes.

[shakil_khan]

configure stpd s0 port link-type edge 1,3 edge-safeguard enable bpdu-restrict

what happens if i put this recovery-timeout 300 command after the bpdu-restrict would it block the port and come to forwarding state after 300 secs (3mins)

[PARTHIBAN_CHINN]

you have to enable BPDU-restrict on those ports.

[shakil_khan]

will the above command make them edge port? and if a device switch/hub is attached to port 3 will it go into blocking state?

[PARTHIBAN_CHINN]

This is ok.