cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 

Extreme Switch x670 bandwidth limited to 3g insted of 10g

Extreme Switch x670 bandwidth limited to 3g insted of 10g

philippe_page
New Contributor
I would like to ask some question regarding our switch. I am testing the bandwidth of our switch. It is currently configured with 10g without any limits on its egress and ingress. However I am only able to get 3g bandwidth instead of 10g. I'll attach the port info detail here for further details:


Slot-1 switch # show port 1:33 info detail
Port: 1:33
Virtual-router: VR-Default
Type: SF+_UNKNOWN (Unsupported)
Random Early drop: Unsupported
Admin state: Enabled with 10G full-duplex
Link State: Active, 10Gbps, full-duplex
Link Ups: 3 Last: Tue Jun 11 21:04:52 2019
Link Downs: 2 Last: Tue Jun 11 21:02:55 2019

VLAN cfg:
Name: storage-net, 802.1Q Tag = 1006, MAC-limit = No-limit, Virtual router: VR-Default
Port-specific VLAN ID: 1006
Name: storage-net2, 802.1Q Tag = 2006, MAC-limit = No-limit, Virtual router: VR-Default
Port-specific VLAN ID: 2006
STP cfg:

Protocol:
Trunking: Master port with 2 members using algorithm address based - L3_L4
algorithm
Members: 1:33,2:33

EDP: Enabled

ELSM: Disabled
Ethernet OAM: Disabled
Learning: Enabled
Unicast Flooding: Enabled
Multicast Flooding: Enabled
Broadcast Flooding: Enabled
Jumbo: Disabled
Flow Control: Rx-Pause: Enabled Tx-Pause: Disabled
Priority Flow Control: Disabled
Reflective Relay: Disabled
Link up/down SNMP trap filter setting: Enabled
Egress Port Rate: No-limit
Broadcast Rate: No-limit
Multicast Rate: No-limit
Unknown Dest Mac Rate: No-limit
QoS Profile: None configured
Ingress Rate Shaping : Unsupported
Ingress IPTOS Examination: Disabled
Ingress 802.1p Examination: Enabled
Ingress 802.1p Inner Exam: Disabled
Ingress 802.1p Priority: 0
Egress IPTOS Replacement: Disabled
Egress 802.1p Replacement: Disabled
NetLogin: Disabled
NetLogin port mode: Port based VLANs
Smart redundancy: Enabled
Software redundant port: Disabled
IPFIX: Disabled Metering: Ingress, All Packets, All Traffic
IPv4 Flow Key Mask: SIP: 255.255.255.255 DIP: 255.255.255.255
IPv6 Flow Key Mask: SIP: ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff
DIP: ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff

Far-End-Fault-Indication: Disabled
Shared packet buffer: default
VMAN CEP egress filtering: Disabled
Isolation: Off
PTP Configured: Disabled
Time-Stamping Mode: None
Synchronous Ethernet: Unsupported
Dynamic VLAN Uplink: Disabled
VM Tracking Dynamic VLANs: Disabled
10 REPLIES 10

Drew_C
Valued Contributor III
What is your test method?
GTM-P2G8KFN