cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 

Failed to upgrade X690 and X440-G2 from 31.7.1.4-patch1-77 -> 32.6.1.5-patch1-2

Failed to upgrade X690 and X440-G2 from 31.7.1.4-patch1-77 -> 32.6.1.5-patch1-2

markus_of
New Contributor III

Hello,

we had some problems with the upgrade to 32.6.1.5-patch1-2 over the weekend. I wanted to ask if this is the case for you too.

When we updated the X690 the 40G ports no longer came up. They were active but we see no connection to the other switch. All 1G ports are working, only the 40G doesen't work. We use the new Image x690-32.6.1.5-patch1-2.xos  (not ONIE). After we roll back .. everything is working. 

When we updated the X440-G2 for some reason, the ssh service was no longer active after the upgrade restart. As soon as it was reactivated via the console port it worked.

Does anyone know the problem?

Best regards,

Markus

 

2 ACCEPTED SOLUTIONS

markus_of
New Contributor III

I found an article that could be our solution to the X690 problem.

Cause

This is a known issue, caused by a Forward Error Correction (FEC) mode being applied during the insertion of 100G optic that then conflicts with the 40G optic.

https://extreme-networks.my.site.com/ExtrArticleDetail?an=000116340&q=X690%20upgrade%20

View solution in original post

James_A
Valued Contributor

Once I hit it a few times, I enabled telnet before the upgrade so I could get in that way, regenerate ssh and then disable telnet again.

View solution in original post

10 REPLIES 10

markus_of
New Contributor III

I found an article that could be our solution to the X690 problem.

Cause

This is a known issue, caused by a Forward Error Correction (FEC) mode being applied during the insertion of 100G optic that then conflicts with the 40G optic.

https://extreme-networks.my.site.com/ExtrArticleDetail?an=000116340&q=X690%20upgrade%20

Stefan_K_
Valued Contributor

In that case the ports would stay down. 

The Error is no longer present in the version you are upgrading to.

If you would have plugged an 100G optic in the past, the 40G optic wouldn't work even before the upgrade.

markus_of
New Contributor III

That's true, but the switch is connected to an MLAG with two X690s and those are the problem (because of the version 31.7.).

We will now update the one again and do the commands on the MLAG switches .

configure port 57 forward-error-correction on cl74

Hopefully it will work out in the end.

James_A
Valued Contributor

There's a bug where the SSH key can get corrupted and have to be regenerated after an upgrade https://extreme-networks.my.site.com/ExtrArticleDetail?an=000076452

GTM-P2G8KFN