ExtremeSwitching (EXOS/Switch Engine) - Page 7 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Resolved! X460 reauth/CoA from Forescout

Hi, does anyone have any experience with reauthentication commands issued from Forescout appliances? I've confirmed that the Forescout appliances are sending the reauthenticate command with the relevant info to the switch, but the switch doesn't seem...

Resolved! Summit X440-24P does not boot up properly!!!

I have a Summit X440-24P switch, recently when i turn it off and turn it on tomorrow it boots up to factory default despite the fact i have primary.cfg configured as my active configuration and image secondary has been configured my active image by U...

Resolved! X440-G2-24p Fan Speeds

What is the go with the X440-G2 fan speeds. We have some of these switches in class rooms and cabinets in classrooms and they are so noisy. We also have some in one of our data centers and its at a much much lower temp, but the same fan speed? Offic...

LACP Monitoring - Schrodinger's OIDs

Snmpwalk works fine# snmpwalk -On -v 3 -l authPriv -u ro -a SHA -A '' -x AES -X '' 192.168.99.211 .1.3.6.1.4.1.1916.1.19.1.1.3 .1.3.6.1.4.1.1916.1.19.1.1.3.3.49.58.56.1008 = INTEGER: 1 .1.3.6.1.4.1.1916.1.19.1.1.3.3.49.58.56.2008 = INTEGER: 2 .1.3.6....

Resolved! x590 how stacking and use of other ports

HiI need to understand how can stack x590 model.From datasheet I don't understand nothing.There are n°1 port (QSFP) and n°2 port QSFP28, stacking is built with QSFP28 ports and it need n°2 ports per switch, I can use QSFP passive cable or QSFP28 pass...

Top Kudoed Authors

User

Count

32

28

20

20

17

GTM-P2G8KFN