cancel
Showing results for 
Search instead for 
Did you mean: 

Hello. Please Help!! X460G2 is running with formware version 22.1.1.5.

Hello. Please Help!! X460G2 is running with formware version 22.1.1.5.

Angel_Pavon1
New Contributor III
My X460G2 was rebooted and upgraded to firmare version 22.1.1.5. This was intermittent about six hours. Then I rebooted again and its up. But can u help me?... What does this los´ mean?

03/06/2017 02:10:22.37 Slot-1: EPM Started
03/06/2017 02:10:22.36 Slot-1: Booting after System Failure.
03/06/2017 02:10:22.26 Slot-2: Booting after System Failure.
03/06/2017 02:10:22.18 Slot-3: Booting after System Failure.
03/06/2017 02:10:21.25 Slot-1: Changing to watchdog warm reset mode

thanks.!!

9 REPLIES 9

Drew_C
Valued Contributor III
Angel, that release is very new and has not received any patches yet. There are a few issues with SSH that I believed are resolved in 22.2, but it also is quite new. That shouldn't be a deterrent, but rather something to consider. Check the release notes for each to review known issues.

Patrick_Voss
Extreme Employee
The fact that all 3 switches rebooted at the same time makes me believe that the power source needs to be looked into.

Tripathy__Priya
Extreme Employee
To me this is something found to be the switch lost power and this is either a power cable problem or the power supplying the switch went out throwing these log message later:

Slot-1: Booting after System Failure.

Angel_Pavon1
New Contributor III
Hi Patrick no I didn´t, just ther rebooted by itselve.

Patrick_Voss
Extreme Employee
Hello Angel,

Did you pull the plug on the switches?
GTM-P2G8KFN