ExtremeSwitching (EXOS/Switch Engine) - Page 290 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Create a new ESI on a CER, 3 ethernet ports, any vlan

I am new to NetIron CER admin. I am trying to create an ESI on a CER, Version 5.2.0cT183 . I need to have 3 ethernet ports be on a separate ESI, just transparent and allowing any vlans, or all just untagged. Just needs to be separate ESI. Is this p...

where is - Network OS Security Configuration Guide ?

hi guys I'm reading "Extreme Network OS Layer 2 Switching Configuration Guide" and in there I read: "For detailed information on configuring ACLs, refer to the "Configuring and Managing ACLs" section of the Network OS Security Configuration Guide." ...

Resolved! Measuring Frame-Delay, Loss, Jitter

Hello everyone! I need for your experience and assistance. I have two Extrme Switch lets say x450 and I need to measure the frame delay , loss and jitter between the two switch for telephone lines. After I will have to implement it to netsight to c...

State description "Unable to resolve IP address from multiple IPs" in NAC End-Systems table.

Hello the HUB ! I am getting trouble with MAC to IP resolution on customer's NAC installation. There are many X440-G2's stacks with 22.4.1.4-patch1-2 EXOS and there is nodealias configured on all access ports. On some ports IP resolution works fin...

Erro:Kern.IPv4Mc.Error - Slot-1: Unable to Add IPmc vlan

Currently using ExtremeXOS version 15.3.5.2 The problem we have is an abundant flow of error messages into the log: code:01/28/2019 13:27:06.10 Slot-1: Unable to Add IPmc vlan 3030 for 1:23 s,G=0,e0000012 IPMC 0, unit 0 Entry exists01/28/2019 13:27...

Top Kudoed Authors

User

Count

28

26

19

18

17

GTM-P2G8KFN