How to quickly see which ports goes up / down via cli - and also see the connected MAC from the Client

[frankygth]

Is there a quick way to see the connected MAC Adress via cli? Also is there a way to see quickly which ports goes up / down. I need to change VLAN’s on selected Ports, and I will discover the clients a) by just switching network down / up - since this is a stacked 48/48 Ports Switch it would be good to only filter by recent changes in up/down. Is this possible. 

2. I would also be able to see the connected MAC Adress, so I could verify if it is the right port.

I would like to do this via cli. I need to put selected Clients in a different Vlans...

Thank You very much

[frankygth]

ok, this sounds promising. So if I’m not mistaken the command shows me the MAC via port or the connected MAC via VLAN. Therefore I could just check the MAC on the Client and find the port that way. 
Is there any way to search for an MAC Adress on the switch (cli)?

[Miguel-Angel_RO]

frankygth,

did you tried “show fdb port ?” and “show fdb vlan ?” to see if it meet your needs?

Mig