Inter-VLAN Routing not working correctly

[IT-SA]

Hello!

I just took over a System Administrator role for a company and trying to figure out what happened to one of their VLANs.
I am new to the Extreme Network devices. They currently have 3 stacked X450-e as their main switch stack/router.
The previous SA setup a new VLAN (VLAN11) to free up some IPs on the main subnet.
Some PCs started dropping from the network last week and we ended up figuring out that the VLAN had been removed from the switch configuration.
I readded it and tried to set everything up as it should be but its not working and I am starting to bang my head against the wall and need some other eyes on this to tell me where the issue might be.

I've gone through all the help guides on here and cannot get a PC to ping another PC on VLAN11 from VLAN1. I cannot even get VLAN11 to pass DHCP to the PC. Static set IP doesn't work either.
DHCP server IP is 192.168.0.17

Here is my current switch config:

[IT-SA]

Just did that and same. Going to remove and call it a night. I'll resume tomorrow afternoon. Thank you for all your help!!!

[Eric_Burke]

Unconfig that and instead add it to default - I think I read it backwards. Rob's example does not show it but it looks like the docs show it. The vr-default is just the router instance that the vlan's live in. It reads like it needs to have the vlan passed into the config where the server lives too.

[IT-SA]

I just added the configure bootprelay vlan vlan11 add 192.168.0.17
Doesn't seem to help 2:13 getting an IP.

[Eric_Burke]

Here's a link to a GTAC article on it. https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-apply-a-bootprelay-dhcp-server-to-a...

[Eric_Burke]

enable bootprelay x.x.x.x enables it globally, enable bootprelay vlan v11 enables for that vlan, config bootprelay v11 add x.x.x.x sets up the relay agent for that newly enabled vlan.