Trying a SFP from RAD in a Extreme X440-G2-24t-GE4. using the SFPs in the back of the chassis. When connected the state on the switch is Enable Ready. When I put the SFPs in a 440-G2-24P the ports come active and I am able to communicate with them.
The difference is that the 24P I am using the front SFP and the 24T I am using the rear SFPs.
The SFP that I am using are RAD MiRICi-E1T1. It is essentially an Ethernet-to-E1/T1 bridge in an SFP form factor.
The SFP-side is a gigabit Ethernet interface that plugs into any MSA-compliant SFP slot and provides Ethernet connectivity to the switch.
The ‘outside’ port on the SFP is an RJ45 E1/T1 connection.
Are there any licensing requirements on port 25-28 of a 24t-GE4 switch that would be preventing the link from coming up?
When you have rear SFP Ports, this is a 10GE4 Model with SFP+ Ports on the rear.
That means, you need to configure these ports to speed 1000 if you are using 1G modules. modules with less than 1G wouldn't work
