Hi
i have problem to assing IP to MAC based authentication (printer) on a x440 single port.
situation looks like below:
computer---
computer--- desktop switch ----- x440 switch single port
printer-------
all dot1x sesions (users) are accepted and works fine but MAC session is not.
Port : 43
Authentication : 802.1x, mac-based
Port State : Enabled
Authentication Mode : Required (Policy Enabled only)
Max Supported Users : 256 (Policy Enabled only)
Allowed Users : 128 (Policy Enabled only)
Current Users : 3 (Policy Enabled only)
------------------------------------------------
802.1x Port Configuration
------------------------------------------------
Quiet Period : 300
Supplicant Response Timeout : 120
Re-authentication : On
Re-authentication period : 0
Max Re-authentications : 3
RADIUS server timeout : 120
------------------------------------------------
MAC Mode Port Configuration
------------------------------------------------
Re-authentication period : 7200
Re-authentication : On
Authentication Delay : 120 seconds
------------------------------------------------
Netlogin Clients
------------------------------------------------
MAC IP address Authenticated Type ReAuth-Timer User
00:0f:fe:xx:xx:xx 0.0.0.0 Yes, Radius 802.1x 0 user
00:23:7d:xx:xx:xx 0.0.0.0 Yes, Radius MAC 4385 00-23-7D-XX-XX-XX
94??80:xx:xx:xx 0.0.0.0 Yes, Radius 802.1x 0 user
-----------------------------------------------
(B) - Client entry Blackholed in FDB
On NAC manager i see that user (dot1x) sesions are resolving ip addresses using radius server which is visible in request (in table), but mac sessions are not.
when i switch printer direct to x440 port, all works fine.
Please help
Regards Mark
