OSPF Troubleshooting quesitons..

[yuvi]

The problem right now is that our outbound traffic is only using one of our many MPLS pipes. And i reckon this is because there is only one advertising router for those networks.

1. We have multiple ISP routers redistributing routes (they say they do) into our OSPF network. But on our internal routers i only see one entry in the LSDB. Is this normal ..or is our ISP lying

2. The VLANs added to EAPS are also the ones with interfaces on OSPF.. so would EAPS be preventing OSPF LSAs ?

[yuvi]

show configuration ospf#
# Module ospf configuration.
#
configure ospf routerid 172.20.11.1
enable ospf
enable ospf export static Export_Statics
create ospf area 0.0.0.15
create ospf area 0.0.1.0
configure ospf add vlan XYZ area 0.0.0.0 passive
configure ospf add vlan XYZ-ABC area 0.0.0.0 passive
configure ospf vlan Default priority 0
configure ospf add vlan SITE1-SITE2 area 0.0.0.0 link-type point-to-point
configure ospf add vlan DATA area 0.0.0.0
configure ospf add vlan ROUTER-1-2 area 0.0.0.0 link-type point-to-point
configure ospf add vlan QWERTY area 0.0.0.0 passive

[andreas1]

EAPS will not block any LSAs. Can you post a snippet of your OSPF config maybe ?

[yuvi]

Simit,

Thanks for the reply, can you clarify on the point you made " EAPS should not prevent OSPF LSA untill and unless the port is in active for the EAPS domain."...

port is "in active" ? as in ?

[Sumit_Tokle]

You should see one routes in the routing table but multiple in LSDB. EAPS should not prevent OSPF LSA untill and unless the port is in active for the EAPS domain.

I