09/18/2014 11:21:31.53 Slot-1:
Unable to set IPMC index for s,G,v=ac13b243,effffffa,233 IPMC 8, unit 0 Invalid parameter
09/18/2014 11:21:31.53 Slot-1: Bcm not found SetBCM IPMC index for s,G,v=ac13b243,effffffa,233 IPMC 8, unit 0 00000000 00000...
If Extreme Networks switches are using VRRP and other devices are using it also in the same VLAN, the Exterme XOS switches will complain loudly about that … one log line per broadcast. In my case it were two per second and as the switch stores only ...
Note to TAC:
TAC needs to check if there is any invalid pointer present in SuperVlan's code that is trying to access invalid address. In the error message there is also the stack, take a look at it in order to identify where is the error.
Rod, I think you should share the dmesg o/p with TAC engineer to further troubleshoot issue. It seems the issue you were facing in old version is not resolved in new version tool
Looking at above o/p it's difficult to understand why code is referenc...
Note that in EXOS 21.1 and higher, a one-time failsafe exists. For information on this process, see How to access an EXOS switch using a one-time failsafe password
The following mandatory TLVs are not configured by default in EXOS: LLDP-MED Capabilities
LLDP-MED Network Policy
LLDP-MED Extended Power-Via-MDI TLV Use the following commands to configure them and allow the switch to communicate with the pho...
I would suggest to refer below URL this would definitely help you.
https://community.extremenetworks.com/extreme/topics/virutal-exos
https://community.extremenetworks.com/extreme/topics/virtual_exos
https://gtacknowledge.extremenetworks.com/articles...
