cancel
Showing results for 
Search instead for 
Did you mean: 

Setting up vlan trunk

Setting up vlan trunk

Ryan
New Contributor II
Hello all,

I want to start by stating that I am new to Extreme and managed switches for that matter. I am having trouble getting a vlan to work with my setup and I know its lack of knowledge that is getting me stuck on this issue.

Scenario: I have a Ubiqtuiti USG and 2 Ubiquiti AP's. I have 2 SSID's running on them. One is the main network and the other is guest. I have the main network not vlan tagged and its working as it should. The problem is that I can't get the guest network running as it should on vlan 10 and with it in an unmanaged switch it is fine, but when I add it to the managed extreme 450e-48p it wont even hand the IP out. My main network is on 10.0.0.0/8 and my guest network is on 172.168.15.1/16.

What I have done:
create vlan guest
config vlan guest tag 10
config vlan guest add port 17 tagged (ports the AP is plugged into)
config vlan guest add port 18 tagged <^



Thank you in advance and if I am missing anything that needs to be here to figure this out, let me know and I will post it.

Thank you

18 REPLIES 18

Ryan
New Contributor II
X450e-48p.27 # show vlan
---------------------------------------------------------------------------------------
Name VID Protocol Addr Flags Proto Ports Virtual
Active router
/Total
---------------------------------------------------------------------------------------
Default 1 10.0.1.254 /8 -----------T------------ ANY 9 /50 VR-Default
guest 10 172.168.255.254/16 ------------------------ ANY 2 /2 VR-Default
Mgmt 4095 -------------------------------------------- ANY 0 /1 VR-Mgmt
---------------------------------------------------------------------------------------
Flags : (B) BFD Enabled, (c) 802.1ad customer VLAN, (C) EAPS Control VLAN,
(d) NetLogin Dynamically created VLAN, (D) VLAN Admin Disabled,
(E) ESRP Enabled, (f) IP Forwarding Enabled,
(F) Learning Disabled, (i) ISIS Enabled, (L) Loopback Enabled,
(l) MPLS Enabled, (m) IPmc Forwarding Enabled,
(M) Translation Member VLAN or Subscriber VLAN,
(n) IP Multinetting Enabled, (N) Network Login VLAN, (o) OSPF Enabled,
(O) Flooding Disabled, (p) PIM Enabled, (P) EAPS protected VLAN,
(r) RIP Enabled, (R) Sub-VLAN IP Range Configured,
(s) Sub-VLAN, (S) Super-VLAN, (t) Translation VLAN or Network VLAN,
(T) Member of STP Domain, (V) VPLS Enabled, (v) VRRP Enabled,

Total number of VLAN(s) : 3
X450e-48p.28 #

f68216d71bf640e58a02175d9a9e6c72_RackMultipart20180714-42404-llja1r-UniFi__8__inline.png



how can I send you the .cfg?

Mine is show above using 68 for my guest network...

Should look something like this...

e66b7b5ed0f34a168c43d6d3433be52d_RackMultipart20180714-128943-sj289b-2018-07-13_22-33-32_inline.png

Eric_Burke
New Contributor III
Ryan, can you send a copy of your overall config as well as a "sho port vlan" and "sho port 17-18 info det"?
GTM-P2G8KFN