sFlow not sampling on x670-48x

[Randy_Middleton]

Any way to show the sflow config without showing all config?
Not getting samples. What am I missing here?

X670-48x
Image : ExtremeXOS version 15.6.1.4 v1561b4 by release-manager on Tue Sep 30 14:06:19 EDT 2014
BootROM : 2.0.1.7
Diagnostics : 6.3
....
configure sflow poll-interval 30
configure sflow collector 10.90.2.19 port 6343 vr "VR-Default"
configure sflow agent ipaddress 10.25.1.5
enable sflow
....

SFLOW Statistics

Received frames : 10341258740
Sampled Frames : 0
Transmitted Frames : 110895
Broadcast Frames : 33825358
Multicast Frames : 27781614
Packet Drops : 0
....

# sh sflow config
SFLOW Global Configuration
Global Status: enabled
Polling interval: 30
Sampling rate: 8192
Maximum cpu sample limit: 2000
SFLOW Configured Agent IP: 10.25.1.5 Operational Agent IP: 10.25.1.5
Collectors
Collector IP 10.90.2.19, Port 6343, VR "VR-Default"

SFLOW Port Configuration
Port Status Sample-rate Subsampling Sflow-type
Config / Actual factor Ingress / Egress
1 enabled 8192 / 8192 1
2 enabled 8192 / 8192 1
3 enabled 8192 / 8192 1
4 enabled 8192 / 8192 1
5 enabled 8192 / 8192 1
6 enabled 8192 / 8192 1
7 etc... all 48 ports

From GTAC KB, but did not change anything...

Resolution
Unconfigure sflow collector by typing the command:

• unconfigure sflow collector

Configure sflow collector by typing the command:

• configure sflow collector port vr

[Andrew_Maldonad]

Randy,

Was sflow previously working or is this a new setup? Please post the output of "show configuration etmon."

-Andrew

[Randy_Middleton]

Thank you. Yes, it can ping.

Collector to switch and switch to collector, zero loss.

[Andrew_Maldonad]

Randy,

The "show configuration etmon" command can be used to view the sflow configuration. Can the sflow collector (10.90.2.19) ping the switch at 10.25.1.5?

-Andrew