- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎01-04-2024 01:28 AM
Hi ,
1.How to configure stacking on 5520 (RH102BF).step by step
2.is it possible to configure separate management ip in stacked switch?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎01-04-2024 02:49 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎01-04-2024 02:30 AM
Hi Nakul,
will you use the native stacking ports (QSFP)? Then just do the cabling* and execute these commands
show stacking
verify that all switches are listed here. After that execute:
configure stacking easy-setup​
Switch will be stacked and rebooted automatically.
*Cabling is done as follows (copied from GTAC):
- Connect all nodes using the stacking ports.
- Keep in mind that stack port 2 (the higher number port) of switch A should be connected to stack port 1 (the lower number port) of switch B. This pattern continues down the stack.
- If you have enough cables to create a full ring, connect stack port 2 of the last switch back around to stack port 1 of the first. This adds additional redundancy in case of cable failure.
Regarding your second question:
You want to have a dedicated IP-Address for each physical switch in the same stack? That isn't possible. And I don't know why this should be required.
Best regards
Stefan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎01-04-2024 02:46 AM
HI stefan,
Thnk u for ur valuable comments.in my switch i am going to use QSFP port 25 & 26.so as per ur comment i should connect like port no 26 th of primary switch to port no 25 th of secondary switch .correct?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎01-04-2024 02:49 AM
Correct!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎01-04-2024 03:09 AM
Thank you
