ExtremeSwitching (EXOS/Switch Engine) - Page 8 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Resolved! x450e-48p Loses config after power loss

Recently got my self a x450e-48p second hand. And i love it. But im having a bit of issues 1. Cant change the time in the ui and dont know how to change it at all right now it is onMon Feb 9 19202. Cant seem to find where i can get any software updat...

ARP not working for one VLAN in trunk

I have a X460G2-24x-10G4 connected to a customer's Cisco Catalyst C8200 on port 23 with VLANs 12 and 21 tagged there.I can see the MAC address from the Catalyst on VLAN 12 but not VLAN 21The tagging of the VLANs is identical in the Extreme switch and...

5420M failing POE check with Fluke LinkIQ

Attempting to figure out why POE is denied with an overload fault when doing a POE load test with a new LinkIQ. It works fine with a Linkrunner G2. show inline-power configuration ports 23 Port Config Operator Priority Detection ...

X770 MGMT port not working

I have configured MGMT port on Extreme X770, following the recommendation from EXOS document, however, 1 out of 6 switches does not work. The issue is that,it seems the MGMT port does not send or receive any package at all. when outside pings the MG...

Issues with IPv6 on EXOS 22.2

Hi all, I experienced problems with IPv6, local services and 22.2.1.5 firmware. When I upgraded to this version, I could no longer access the switch through ssh or telnet ports using IPv6 address, but only with IPv4 address. Nmap pointed to IPv6 sw...

Top Kudoed Authors

User

Count

28

26

19

18

17

GTM-P2G8KFN